Wenn ich versuche Skynet auf meinen Anet A8 hochzuladen bekomme ich folgende Fehlermeldung
Arduino: 1.8.0 (Windows 10), Board: "Anet V1.0"
Der Sketch verwendet 116120 Bytes (88%) des Programmspeicherplatzes. Das Maximum sind 131072 Bytes.
Globale Variablen verwenden 4508 Bytes des dynamischen Speichers.
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xd6
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x6f
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x80
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0xbf
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0xae
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0xd6
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x02
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x21
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0xcc
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0xd6
Beim Hochladen des Sketches ist ein Fehler aufgetreten
Was kann das sein ? Danke euch schonmal.